Dynojet 224: Pit Eddy Current Brake - Manual (Page 31)

TO R Q U E M O D U L E I N S T A L L A T I O N
Torque Module Installation
Version 2 Model 224 Pit Eddy Current Brake Installation and User Guide
2-5
I NSTALLING THE T ORQUE M ODULE
1 Verify the main dyno power is disconnected.
2 Turn off the main power switch on the CPU Module on the dyno electronics and
unplug the power cord.
3 Remove the dust cover from the existing top module.
Figure 2-4: Remove Dust Cover
4 Loosen the top right screw on the back of the existing top module.
5 Plug the Torque Module into the existing top module. Place the dust cover,
removed in step 3, on the Torque Module.
6 Secure the grounding strap on the back of the Torque Module to the existing top
module.
Figure 2-5: Secure Grounding Strap
dust cover
power cord
input
power switch
grounding strap