Dynojet Analog Module - Manual (Page 7)

A N A L O G M O D U L E I N S T A L L A T I O N
Analog Module Installation
Version 1 Analog Module Installation and User Guide
1-3
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ANALOG MODULE INSTALLATION
This section describes how to access the dyno electronics, install the Analog Module,
route the Analog Module cable assembly, and connect the sensor cables.
C ONNECTING AND D ISCONNECTING P OWER TO THE D YNO
Always disconnect the power before beginning any installation procedures.
Refer to your dyno installation manual for more information on disconnecting the
power to your specific dyno.
1
Use the main breaker to turn power on and off to the dyno.
2 Disconnect the power plug to ensure all power has been removed from the dyno.
A CCESSING THE D YNO E LECTRONICS
You will need to access your dyno electronics in order to add the Analog Module. Use
the following steps to access the dyno electronics.
1
Turn off the main power to the dyno.
To prevent possible injury always disconnect all power to the dyno.
2 Locate the dyno electronics enclosure.
Refer to your dyno installation manual for more information on locating and
accessing the dyno electronics encloser.
3 Remove the twelve screws securing the cover and lift the cover off.
Figure 1-1: Remove Electronics Enclosure Cover