Dynojet Analog Module - Manual (Page 9)

A N A L O G M O D U L E I N S T A L L A T I O N
Analog Module Installation
Version 1 Analog Module Installation and User Guide
1-5
I NSTALLING THE A NALOG M ODULE
1 Verify the main dyno power is disconnected.
2 Turn off the main power switch on the CPU Module and unplug the power cord.
3 Remove the dust cover from the existing top module.
Figure 1-3: Remove Dust Cover
4 Loosen the top right screw on the back of the existing top module.
5 Plug the Analog Module into the existing top module. Place the dust cover,
removed in step 3, on the Analog Module.
6 Secure the grounding strap on the back of the Analog Module to the existing top
module.
7 Secure the Analog Module to the dyno electronics with the plastic tie straps (one
on each side).
Figure 1-4: Secure Grounding Strap
dust cover
power cord
input
power switch
grounding strap
plastic tie strap