EFCO E-Lite - Manual (Page 14)

EFCO CORPORATION 6/2012 PART NO. YWLS Page 14 of 19
E-Lite Fabrication, Assembly and Installation Instructions
Section IX: E-Lite “Module Built” Aluminum Panel
1.) Load Aluminum Panels into E-Lite Module Ladder.
Drill and countersink aluminum panel for
Tek attachment screws top and bottom
Aluminum Panel
Top and Bottom
Assembled Module
Ladder Framing
2.) Square the E-Lite Module Ladder to the Panels and Pin.
A.) Assemble components as shown into ladders, tighten all fasteners firmly.
A.)Flush the edges of the aluminum panel with the module ladder and clamp as a unit. Recheck for squareness.
B.)Align drill and countersink the aluminum panels at 12” on center. Pin the panel with the Tek
screws supplied, tighten all fasteners firmly. Make sure the fastener heads are at least flush or
better yet, slightly recessed below the surface of the aluminum panel to minimize interference.