EFCO E-Lite - Manual (Page 17)

EFCO CORPORATION 6/2012 PART NO. YWLS Page 17 of 19
E-Lite Fabrication, Assembly and Installation Instructions
Section XII: E-Lite Module Installation
1.) Install Light Shelf Panel Module into Base.
A.) Load the E-Lite Panel Module into the Base and support temporarily.
B.) Leave a recommended nominal 1/8” gap between the panel modules.
(This gap should be defined on the shop drawings.)
Flush
Attachment Base
Tek Attachment Screws
E-Lite Panel Module
Attachment Base
Note: Typically the top of the Base will be flush with the top of the horizontal mullion.
Horizontal Mullion
Vertical Mullion
Note:
E-Lite MUST NOT bridge any
expansion joint or expansion mullion.