Elecraft KX3 Owner's Manual - Manual (Page 43)

43
XVn ADR TRNn Assigns optional band-decode addresses to transverter bands. Addresses T R N 1 - 7
can be used to select Elecraft XV-series transverters if the ACC2 IO menu entry
is set to
T R N C T R L and the transverters are connected to the ACC2 jack
(tip=auxBus, ring=key out). TRN0 is used with the KX3-2M/4M module
(internal). Tap
1 – 9 to select the transverter band; rotate VFO A to select the
address.
To configure an Elecraft KX3-2M 2-meter module as XVTR band 1, set XV1
ON to
Y E S , XV1 RF to 144 MHz, XV1 IF to 50 MHz, and XV1 ADR to IN T
T R N 0 . For the KX3-4M module, use 70 MHz for RF and 21 MHz for the IF. The
XV1 OFS menu entriy is not applicable in either case. Set and XV1 PWR to the
desired maximum power output on 2 or 4 meters, in watts (max 3.0; reduce power
if 2- or 4-meter antenna SWR is poor or when using internal batteries).