Elecraft KX1 Manual - Manual (Page 62)

E
LECRAFT 61
Components on the bottom of the board must have an overall
height of no more than about 1/8” (3 mm) above the PC board in the
area shown below (See Figure 29 ). Fold down or re-solder
components if necessary. Also trim any long component leads which
were not trimmed earlier.
Figure 29. Checking Component Clearance.
Set the chassis (top cover and circuit boards) next to the bottom
cover as shown in Figure 29 and attach battery connector J5 to plug P1
on the main circuit board.
i
When you install the bottom cover in the next step, be sure
not to pinch the battery cable under the nearby long standoff.
Fit the bottom cover in place and secure it with the two 4-40
black knurled thumbscrews.
This completes assembly of your KX1 Transceiver. You should have
a number of washers, screws, and other hardware left over. These
items have been provided as spares. Please read the Operation section,
which follows, and try each of the KX1's features. If you're new to
QRP, be sure to read the QRP Operating Tips section (page 70).
i
If you have purchased KX1 internal options, do not install
them until becoming familiar with basic KX1 operation. Options
can be installed in any order. (All KX1 options are described on
page 71.)