Elecraft KPA100 Manual - Manual (Page 11)

11
Picture Ref. Designator(s) QTY Description Part #
MISC 1 Shield, KPA100, approx. 7.3" W x 6" L (18.5 x 15.2 cm) E100137
MISC 1 Speaker shield, 1.9" diameter (4.8 cm), with self-adhesive pad on inside E980087
MISC 1 Grille cloth, black, approx. 3 x 3" (7.5 x 7.5 cm) E980053
MISC 2 Thermal pad for flange-mount power transistor (Q1 and Q2) E980051
MISC 2 TO-126 thermal pad, self-adhesive (Q3, Q4) E980052
MISC 1 BNC connector cap, plastic (to cap K2's BNC antenna jack) E980006
MISC 26 ft. Enamel wire, #22 red (for all low pass filter toroids) E760018
MISC 9 ft. Enamel wire, #26 red (for T3, T4, L16) E760002
MISC 3 ft. Enamel wire, #26 green (for T3 and T4) E760004
MISC 5 ft. 2-conductor wire, #12 stranded, red/black (for DC power wiring) E760033
MISC 1 ft. RG174 coax (for RF cable to K2 RF board) E760010
MISC 1 10-conductor ribbon cable with pre-installed connectors; 4" long E980045
MISC 1 ft. 2-conductor speaker cable, #24 stranded (for J5 and speaker) E760012
MISC 10 ft. 4-conductor shielded cable (serial I/O cable) E760009
MISC 1 ft. Stranded insulated hookup wire, #20 black (for DC cable to K2 RF board) E760006
MISC 1 ft. Stranded insulated hookup wire, #20 red (for DC cable to K2 RF board) E760007
MISC 1 ft. Hookup wire, #24, solid conductor, green ins. (for K2 Control board mod) E760008
MISC 1 ft. Stranded, Teflon-insulated wire, #22 gray (for T1) E760020
MISC 2 ft. Stranded, Teflon-insulated wire, #18 gray (for T2) E760021
MISC 3 Cable tie, 3" E980002
MISC 1 Allen wrench, .05", short handled (for 1/2" heat sink set screws) E980008
MISC 1 Sand paper, 180-grit (for heat sink preparation) E850090