Electric Eel RF - Manual (Page 7)

Model RF Manual (082610)_2-ColorREV.doc Page 7 of 16
TOOL SELECTION
It is important to choose the proper
cleaning tool for each cleaning
application. See the tools outlined
below.
Standard Tools Included with the
Model RF Kit:
1. SC-18 Spanner Wrench
2. HDD-7 Retriever Tool
3. U3H Grease Tool
4. HDD-3S Root Saw
5. A-1DC Starting Drill Tool
6. 1-FLSC1SC2 Flexible Leader for
Negotiating P-Traps
OPERATING
INSTRUCTIONS
DANGER
OPERATOR MUST BE
THOROUGHLY FAMILIAR
WITH ALL SAFETY
INSTRUCTIONS BEFORE
OPERATING EQUIPMENT.
FOR AUTOMATIC CABLE
FEEDER
1. WITH POWER OFF, attach a
small spear-type cleaning tool to
the end of the cable. This tool
will enable you to bore a starter
hole in the obstruction, allowing
backed-up water to drain.
NOTE: The flexible leader should
be used with the A-1DC Starting
Tool when negotiating P-Traps or
severe bends in the line.
2. Place machine cable guide spring
at pipe opening. NEVER have
exposed cable.
3. Position foot actuator for easy
operator accessibility.
4. Make sure FOR/REV
(Forward/Reverse) switch is
in FORWARD position. Run
machine in FORWARD at all
times during cleaning operation,
use REVERSE ONLY to dislodge
tool lodged in pipe line and/or to
relieve unnecessary build-up of
torque on a cable.
5. Place one HEAVY leather gloved
hand on the cable guide spring
to control cable as it rotates
inside; and use other hand to
work the feeder control lever.
DANGER: Operator must keep one
HEAVY leather gloved hand on
cable guide spring at all times
during operation.
1
2
3 4 5
6