ETS-Lindgren 3184 Broadband Mini-Bicon Antenna - Manual (Page 28)

28 | Mounting Instructions
S TEP 2: M OLD P LASTIC S EAL T APE
• Press firmly and
uniformly over the
plastic seal tape to
mold it into place.
• Squeeze out any
trapped air as you
press the plastic
seal tape.
S TEP 3: W RAP H EAVY -D UTY A LL -W EATHER V INYL T APE
• Start wrapping
1/2 inch below
where the plastic
seal tape begins
and wrap upward to
1/2 inch above
where the seal tape
stops.
• As you wrap, stretch
the vinyl tape
slightly to avoid
creases and
bubbles.
• When done, inspect
the tape to make
sure everything is
covered and sealed.