ETS-Lindgren 2188 Turntable - Manual (Page 28)

Model 2188 Turntable
©ETS-Lindgren—January, 2006
Rev. B—P#399771
28
WARNING: Do not operate the turntable in a stalled condition.
Doing so may cause damage to the drive unit and will nullify your
warranty. Always insure that the minimum speed setting specified
in the S1-S4 parameters is above the minimum value at which your
table will turn under normal load.
5.6. Speed Selection
For the Variable Speed Turntable, the Polarization/Flotation button
provides the ability to cycle between the eight preset speeds
described above. For each press of the button, the turntable will
change to the next speed setting. The polarization LEDs will light
to indicate the speed selection in a binary fashion as shown below:
• Speed 1: Both off
• Speed 2: Top on, bottom off
• Speed 3: Top off, bottom on
• Speed 4: Both on
• Speed 5: Both off
• Speed 6: Top on, bottom off
• Speed 7: Top off, bottom on
• Speed 8: Both on
Each speed setting has its own individual overshoot compensation
value to provide proper overshoot correction for each speed
selection.