ETS-Lindgren 95242-1 Injection Probes - Manual (Page 18)

Test Setup Equipment
The following equipment may be needed to set up the test environment.
• Current Injection Probes: 95236-1
95242-1
• Calibration Jig 95241-1
• Current Monitoring Probes
• Signal Source/Generator
• Power Amplifier(s): The power amplifier should be capable of
supplying the full rated power into the current
injection probes (which have a high VSWR)
with a low harmonic content.
• Spectrum Analyzer or Measuring Receivers
• Directional Coupler
• RF Voltmeter(s)
• RF Absorbing Clamp
• RF Attenuator
• RF Loads
18 | Application