Archived 4/2/10 – ETS-Lindgren HI-4455 Isotropic Field Probe (Archived) User Manual
Page 31
HI-4455 Isotropic Electric Field Probe
© ETS-LINDGREN L.P. – August 2005
Revision D- Part No. H-600076
31
COMMANDS
Command
Description
B
Read battery voltage.
Cx
Set baud rate.
x = 1 sets rate to 2400 baud
x = 2 sets rate to 9600 baud
New baud rate does not take effect until the next
power-up.
Dx
Read probe data.
x = 1 enables short form output
x = 2 enables long form output
Rx Set
range.
x = 1, 2, 3, 4 or N (next range)
Sx Sleep
timer.
x = number of seconds to wait for a command before
putting the probe into the sleep mode.
Tx Read
Temperature.
x = C or F
Ux
Set unit type.
x = 1, 2, 3, or N (next unit)
1 = V/m
2 = mW/cm²
3 = [V/m]²
Vtx
Verify table data.
t = table (same table as for the Lx command, above).
x = number of bytes to send in one string.
Z Zero.
Null
Send the ASCII null character.
This is a special command that can be used as the
initial command to the probe after it is powered up.
The probe responds with “N”.
Archived 4/2/10