FAB Defense SSR-25 Sniper Buttstock - Manual (Page 2)

Fig. 1
1. 4 mm Alen Key
2. 2.5 mm Alen Key
3. Buffer Tube Screw
4. Monopod Spring
1 2
3
4
25
-
Mounting Your Sniper Buttstock SSR
Step 1. Using the 2.5 mm Alen Key (2)
release the Rear Screw (Fig 2).
Fig. 2
Step 2. Pressing the Cheek-Rest Button (a)
slide up and remove the Cheek Rest (Fig 3).
Fig. 3
Attention! The Cheek-Rest Button is spring loaded!
Don’t remove your finger from the Button until the
Cheek Rest is safely off the Buttstock.
Slowly reduce the pressure from the Cheek -Rest Button.
Step 3. Pressing the Monopod Release Button (b),
extract the Monopod Rod (c) and insert the
Monopod Spring (4) as shown in Fig 4.
Fig. 5
b
b
4
Attached parts
Step 4 .
Slide the Buttstock on the Buffer Tube (d)
and tighten Buffer Tube Screw (3) using the
4 mm Alen Key (1) as shown in Fig 5.
3
Fig. 4
d
c
1
a
2