Fat Shark PredatorV2 CE - Manual (Page 7)

Fat Shark 7 RC Vision Systems
Using an external receiver:
Use the AV cable to connect headset to the RCA
AV port of external devices.
To share the base station power supply with your
goggles, pick up a 3m Dominator AV cable
accessory from your retailer. Note; internal
receiver must be shut off to properly display
external AV.
Battery Charging
The 1000 mAh 7.4V lithium polymer battery pack
is equipped with a 3 pole balance charger lead that allows the battery to be
charged off standard RC battery pack chargers (not included). Follow your charger
instructions for setting up for 760 mA 7.4V Li-po. Some chargers require the
discharge cable to be connected. Use the enclosed discharge lead adapter for
these types of chargers.
Note (1): If the charger fails to announce charge complete, but is showing battery
voltage at 8.4V, the charge can be considered finished.
DO NOT LEAVE BATTERY ATTACHED TO CHARGER WHEN CHARGER IS
NOT PLUGGED IN.
Note (2): If battery becomes fully discharged or shorted an internal safety circuit
will trip To reset the battery, tap 9V direct to the barrel connector via the discharge
adapter cable’s banana connector. This will instantly reset the battery and it can
be recharged as normal.