FBT QUBE SP27 - Manual (Page 29)

Unlocking the Unit
To unlock the unit press and then type the code in. This can be entered by using the control to
select a character, and the and keys to move to the next character. Alternatively, the keys
can be used to enter a code by pressing any combination of the eight buttons. Each key represents its
channel labelling, as described in the locking section.
Don't panic! Your unit can still be unlocked. In an attempt to improve the security system on the SP27, and
prevent a standard master password from becoming common knowledge, the units now have a random
password key generator.
The procedure for unlocking a unit using the password override is explained below:
Switch the unit on with the key held in momentarily. After a few seconds, the unit will ask for a security
code. Use the keys in the same manner as for entering lock codes (see page for details) and enter
2121.
The display will show:
Enter Supplied Code:
Break Code = 12345 [NNNN]
The Break Code (in the example 12345) should be noted and supplied. We have software to generate the
corresponding Pass Code which should be typed in, followed by
. This will unlock the unit and wipe
the previous password.
Note the following about this procedure:
Once the Break Code has been noted, do NOT press again during the operation of the unit (except to
get back to this point on power up), or a different code will be generated. The unit may be used as normal, but
every press of
will change the Break Code, so the Pass Code supply will not work!
The unit may be switched on and off as necessary – just be sure NOT to press , or the entire Break
Code procedure will have to be repeated.
ENTER FREQ
BACK NEXT EDIT
EDIT
MENU
EDIT
ENTER
MENU
MENU
MENU
Forgotten the Password?
27