Fiilex P200 - Manual (Page 10)

8
• Do not attempt to disassemble the body of P200 FlexJet.
• Do not install P200 FlexJet in a damp or wet area.
• Do not cover the side and back air vents.
• Use only the included power supply.
Failure to do so may cause damage to the LED light.
• Use only a soft, dry towel to gently clean the exterior of
the light.
• Before turning on the power, please make sure the
Protective Cap (B) and protective membranes are
removed.
Information and Specifications in this document are subject to change without notice. DiCon
Lighting, Inc. assumes no responsibility or liability for any error or inaccuracies that may
appear in this manual. Unlawful reproduction or distribution in any manner without the
written permission of DiCon Lighting, is strictly prohibited.
© DiCon Lighting 1996-2013 All Rights Reserved
Fiilex.com
1689 Regatta Blvd. Richmond, CA 94804
(510)620-5155 . [email protected]