Gastroback 40126 Design Juicer Pro - Manual (Page 12)

OPERATING YOUR DESIGN JUICER PRO
wARNING: Make sure the appliance is completely assembled and that there are nor
foreign objects in the feed chute before putting the plug into the power outlet.
Never put fingers, wooden spoons or other foreign substances (such as hair, clothing,
brushes, cloth) into the feed chute.
Always turn the appliance off and wait for the motor to stop moving before removing the
lid of the juicer.
Keep the working place clean and dry. Do not let any liquids or water run into the motor
block.
Do not put any cloth or napkins underneath the appliance to avoid endangering by fire
and voltage. In case that water or other liquids ran into the motor block while operating
turn off the appliance immediately, pull the plug and dry the appliance with a clean cloth.
operate according to the instructions ›trouble shooting guide‹.
Step1:
Wash your selection of fruit and vegetables before juicing.
NOTE: Most fruit and vegetables such as small apples, carrots and cucumber will not need
to be cut to size as these will fit into the feed chute. When juicing carrots place the tip of
the carrot into the feed chute last.
Step 2:
ensure the juicer is correctly assembled. ensure the stainless steel filter is thoroughly
cleaned before each use (refer to ›care and cleaning‹). ensure you place the juice jug
under the spout before commencing juicing.
Step 2 a: working with the juice jug
the juice jug consist of the jug with scale, a
froth separator and the lid. Insert the froth
separator from the top into the jug and
close the jug with the lid. Place the juice jug
infront of the spout and ensure that the juice
can run right into the jug. this way you can
avoid splatter.
ATTENTION: ensure not to overfill the
juice jug when operating the juicer. over
floating liquid could run under the motor
block and cause damage to the appliance.
Step 3:
Plug the power cord into a 220-2240V
power outlet and turn the power on. Push
the ›oN/oFF‹ button to ›oN‹.
44