Gastroback 40126 Design Juicer Pro - Manual (Page 13)

OPERATING YOUR DESIGN JUICER PRO Step 4:
With the motor running, place food into the
feed chute. using the food pusher, gently
guide food down the feed chute.
to extract the maximum amount of juice,
always push the food pusher down slowly.
Step 5:
Juice will flow into the jug and the sepa-
rated pulp will accumulate in the integrated
pulp container.
ATTENTION: Do not allow the pulp con-
tainer to overfill as this may affect the
operation of the appliance (refer to disas-
sembling instructions). Reassemble machine
to continue juicing.
to minimise cleaning, line the pulp con-
tainer with a plastic freezer bag to collect
the pulp.
EmPTY ThE PUlP CONTAINER DURING JUICING
the pulp container can be emptied during juicing by turning the appliance off at the control
panel and then carefully removing the pulp container. Remove the pulp container by tilting
the pulp container slightly to the right and unlatch it from under the juicer cover and the
container support extending from under the motor base. Replace the empty pulp container
into position before continuing to juice.
NOTE: Do not use force removing the pulp container to avoid damage to the juicer cover.
NOTE: In case that the appliance slows down, stumbles or stops all of a sudden turn off
the appliance immediately and pull the plug to avoid overheating. operate according to
the instructions ›trouble shooting guide‹.
wARNING: Never use fingers to push food down the feed chute or to clear the feed
chute. Always use the food pusher provided.
NOTE: Pay attention not to overflow the jucie jug.
As soon as you finished operating turn the appliance off. Always turn the appliance off and
pull the plug when the appliance is not in use and you finished the operation.
clean the appliance in accordance to the instructions in chapter ›care and cleaning‹. Do
not leave any food dry on the surfaces of the appliance or the filter basket.
44 45