Gastroback 41000 Design Mixer Advanced - Manual (Page 22)

The bottom of the blender jug Turn the appliance ‚OFF‘ and pull the plug out of the power outlet.
untightens during operation; Empty the blender jug. Clean and dry the motorblock.
liquid leaks. If any ingress of moisture into the motorblock or through the louvre take the appliance
for technical maintenance and repair to an authorised specialised reparation shop.
Ensure the blender jug is properly assembled.
TIP: Before filling liquid into the blender jug check if the blender jug is leak-proof by filling it
with water. Check the sealing ring. If necessary replace damaged units by original spare parts
of the manufacturer.
It is not possible to get the Empty the blender jug. Disassemble the blender jug and check if there are crusts or damages
blender jug leak-proof; on the single units. Clean the units if necessary.
Liquid leaks from the bottom
of the blender jug. Replace damaged units by original spare parts of the manufacturer.
Assemble the blender jug according to the instructions.
ATTENTION: Never use the appliance with improper or damaged units.
Only use spare units provided and made by the manufacturer. Contact you vendor for help.
The blender jug is screwed on too Ensure to screw the holder clockwise to get it loose.
tight to the holder.
Slide your hand through the handle of the blender jug. The handle should be behind
the back of your hand. Grab the holder with your other hand and screw the holder
1/4 turn clockwise.
Ask someone to hold on to the blender jug while you screw the holder with both hands.
TIP: It is easier to loosen the blender jug if you put a drop of vegetableoil onto the sealing ring.
Food is unevenly chopped Either too much food is being chopped at one time or the pieces are not small enough.
Try cutting food into smaller pieces of even size and processing a smaller amount per batch.
For best results the food should be chopped into pieces no larger than 2cm.
Food is chopped too fine or The food is over processed. Use brief pulses or process for a shorter time.
is watery
Food sticks to blade Processing too much food. Turn the blender off by pressing the ´POWER` button on the control
panel. Then switch off at the power outlet and unplug the power cord. When the blade stops
rotating, remove the blender lid and remove some food with a spatula.
Waste disposal
The appliance has to be deposed by the definition of the regional waste disposal of
electricalscrap.
If necessary get information of the regional waste management enterprise.
22