Cub Cadet 8354 - Manual (Page 48)

48
Figure 78
• If a fuse continually fails, have the electrical
harnesses check by your Cub Cadet dealer or a
qualified electrician.
Main Slow Blow Fuse
• Locate the slow blow fuse in the wire harness
behind the left side panel. See Figure 79.
Figure 79
• Remove the coupling and replace the old slow
blow fuse with a new one.
IMPORTANT: The slow blow fuse serves to protect
the electrical system. If the fuse blows, have the
tractor electrical system checked to find the cause.
Never substitute a different fuse.
TIRE MAINTENANCE
Check the tire air pressure before each use. Keep the
tires inflated to the recommended pressures.
Improper inflation will shorten the service life of a tire.
See the tire side wall, or the Tire Inflation chart, for
proper inflation pressures.
• Do not inflate a tire above the maximum pressure
shown either on the sidewall of the tire or the Tire
Inflation chart.
• Do not reinflate a tire that has been run flat or
seriously under inflated. Have a qualified tire
mechanic inspect and service the tire.
• WHEN SEATING THE BEADS, NEVER INFLATE
A TIRE OVER 35 PSI. If the tire beads have not
seated at or before 35 PSI, allow the tire to
deflate. Reposition the tire on the rim, lubricate
the tire beads and rim flanges, and reinflate until
seated - up to a maximum of 35 PSI. Inflating a
tire with unseated beads beyond 35 PSI could
break the bead or rim with sufficient explosive
force to cause a serious injury.
WARNING: Servicing tires can be danger-
ous. Whenever possible, trained person-
nel should service and mount tires.
15A Spare
10A Horn, Cab Lamp 10A PTO
25A Turn Signal Lamp
Timer Relay
20A Rear Lamp
Head Lamp
20A Working Lamp
15A Wiper 10A Backup Lamp
10A Brake Lamp 10A Start Switch "ON"
Slow Blow Fuse
Classification Tire Size
Inflation
Pressure
Front Tires 7-16 4PR
8-16 6PR 25.7 psi
22.9 psi
Rear Tires 11.2-24 6PR
12.4-24 6PR
13.6-24 6PR 25.7 psi
22.9 psi
22.9 psi