General Hydroponics AF36 - Manual (Page 3)

ASSEMBLY
STEP 1
Place the Reservoir where it will be used on a
level surface. Line the inside of the Reservoir
grommet with a thin coat of the Silicon Grease.
Insert Drain Valve into grommet using a
twisting motion.
STEP 2
Attach the pipe thread adaptor provided with
the WaterPower 85 Pump to the outlet. Then
attach the Pump Line to the outlet adaptor;
making sure the Pump Line is fully seated
against the “O” Ring.
STEP 3
Place the WaterPower 85
Pump on the bottom of
the Reservoir and feed the
power cord through the hole
in the Reservoir Lid. Lower
the Reservoir lid guiding the
Pump Line through the same
hole as the power cord.
STEP 4
Remove the Laser Sprayline, Drain Level Tube, Net Pots and CocoTek Liners from each of
the Growing Chambers. Follow the included directions on inserting the Laser Spraylines
into each Growing Chamber.
Line the inside of the Growing Chamber grommet
with a thin coat of the Silicon Grease and insert the
Drain Level Tube half way into the grommet. Repeat
for the rest of the chambers. The water level of the
Growing Chambers is adjusted by raising or lowering
the Drain Level Tubes.
STEP 5
Assemble the SnapStand by sliding the
two Support Legs into the SnapStand
Bases and the SnapStand Cross Fittings.
Snap the Cross Support into the
SnapStand Cross Fitting and place the
StanpStand approximately 5’ from the
reservoir. Center the Growing Chambers
with the Drain Level Tube inserted into
the Drain Overflow Hole and the other
end on the SnapStand.