Hollywood Racks HR135 Tow N Go - Manual (Page 3)

Fig. B Vertical Cylinder
Caution when using this rack and NOT towing!
This bike rack can also be used when not
towing, however your trailer hitch receiver tube
(or “stinger”) is most likely not to include an
anti-wobble device. An anti-wobble device
such as a threaded hitch pin is intended to
keep the rack stable during use. Hollywood
Racks strongly recommends that you either
purchase an “after market” anti wobble device
for your hitch or use some tie-down straps to
secure the rack to the vehicle to prevent any
rack movement. If you have any questions on
how to do this, please call us at 800-747-4085.
2006 through 2008 version
After opening the Tow N’ Go box,
you should have the following parts:
1. Parts bag including:
a. Two black threaded knobs
b. Two pivoting spacer blocks
c. Allen wrench for set screws.
2. Upright “T” shaped main beam
3. Two Support arms with bike
separators attached.
4. Nine rubber straps & Safety tie-down
strap
FIG. A: Black threaded knob
and spacer block
Installing the support arms:
Insert the knob through the spacer as shown in
Fig. 1 (the knob should be against the flat end of
the spacer block). Align the threaded hole in the
vertical cylinder (fig. 2) so that it faces out. You
can rotate the vertical cylinder using a coin or
flat blade screwdriver in the slot at the top of the
vertical cylinder. Insert the knob through the
support arm, and thread the knob into vertical
cylinder inside the main top horizontal tube.
Repeat for the Driver’s side arm.