Canon FS 2720 U - Manual (Page 16)

16 CanoScan FS2720U Film Scanner
7. Open the dust cover.
• Insert your fingertips into the notch on either side of the dust cover and pull it
gently down.
8. Insert the film holder into the scanner.
• Hold the film holder horizontally on edge as shown below, orienting it so that
the orange mark is on the left side. Insert it straight into the scanner until the
orange mark on the guide lines up with the orange mark on the scanner.
• If the film holder is inserted at an angle, the guide position may be altered
and you may not be able to insert it properly.
• Ensure that the film holder is oriented according to the diagram below so
that the guide is correctly inserted. The film holder will not fit correctly into
the slot if the guide is incorrectly oriented.
• Film holders can be purchased separately if the supplied one is broken or
damaged. Inquire at the distributor from which you purchased the scanner.
Dust Cover
Orange Marks
Viewed from Above
The orange
mark should
be on the left.
The ‘R’ should
be correctly
oriented
when viewed
from the left.