JDC Electronic SA EasyFlow - Manual (Page 7)

7
MADD Technologies sàrl
– Avenue des Sports 42 – CH-1400 Yverdon-les-Bains – Switzerland
Tel: +41 24 445 31 16 – Fax: +41 24 445 21 23 – Email: [email protected] – www.madd.ch
Multimetre mode
This function permits to use the EasyFlow for punctual water quality measurements.
From the main menu, choose with the button SELECT the mode Multimetre then press the button ENTER. At
this moment the device measures continuously the salinity and the temperature. Press on SELECT to switch
from salinity measurements to the temperature.
To go back to the main menu, just press on ENTER. In this mode, without touching any button, the device will
automatically shut down after 1 minute.
Visualisation of the last measurement
After a gauging, it is always possible to visualise the value of the last computed
flow rate. Select Last measure in the main menu.
The button ENTER permits to return to the main menu.