Karcepts KSM03 - Manual (Page 6)

Left edge of sheet metal
surrounding shifter hole
Longer straight side of
template (make parallel)
2. MODIFYING YOUR CHASSIS (continued…)
5. The paper template is a bit flexible, so as best you can, keep the longer straight
side of the template parallel with the left edge of the sheet metal surrounding
the shifter hole; then mark the centers of the two upper holes. Before marking
the cut-out for your chassis, we will confirm the hole locations in the future
steps.
Once parallelism is confirmed, mark
the centers of the holes for drilling.
6. Center punch and drill two 9/32” holes where marked.