Karcepts KSM03 - Manual (Page 9)

2. MODIFYING YOUR CHASSIS (continued…)
10. Attach the left and right front mount brackets to the shifter mount with two of
the 1/4" cap screws (3/8" long) and 1/4” lock washers. Square up the brackets
by holding them with a pair of pliers while tightening. Make certain to observe
the pictures below to properly identify where each bracket goes, as they are not
identical.
Tapered side of left bracket
Wider (left) bracket on this side; taper on top
11. Hand tighten the shifter mount to the rear mount bracket utilizing two of the 1/4"
cap screws (1/2” long), 1/4” lock washers, and 1/4” flat washers.