KMC Controls KMD-1162 - Manual (Page 7)

KMD–1162 Installation and Operation
7
Changing the setpoint
Pressing either the up or down setpoint buttons changes the display
from room temperature mode to setpoint mode. Pressing either
button once displays the current setpoint for three seconds; each
additional press increments or decrements the setpoint temperature
by one degree Fahrenheit.
Backlight
When either setpoint button is pressed the backlight turns on and
remains on for 10 seconds after the last button is released.
Programming instructions
Programming instructions for NetSensors are included in Help
supplied with WinControlXL, BACstage, and TotalControl.
Maintenance
Remove dust as necessary from holes in top and bottom. Clean the
display with soft, damp cloth and mild soap.