KMC Controls MCP-3631 Series - Manual

MCP-3631 Series 1 Installation Guide
Installation Guide
Rotary Pneumatic Damper Actuators
MCP-3631 Series
Mounting
Mounting Method #1, for 1/2-inch diameter shafts
1. Locate a 3/16-inch cross-hole in the shaft.
2. Align the hole parallel, or perpendicular, to the damper blade
depending on how the actuator will be mounted and whether
the damper is to be Normally Open or Normally Closed.
3. Insert drive pin (HLO-1008) and slide actuator onto the shaft to
engage.
4. Note the direction of rotation.
5. Slide the retainer (HLO-1009) onto the shaft to lock actuator.
6. Rotate the actuator to the desired damper position.
7. Install the anti-rotation bracket (HMO-1003) provided.
Mounting Method #2, for 1/2-inch diameter shafts
1. Slide the HLO-1016 collar onto the shaft.
2. Slide the actuator onto shaft noting directional rotation.
3. Slide drive bushing (HLO-1006) onto the shaft and into the
actuator.
4. Align the actuator with the damper.
5. Lock the collar and drive bushing setscrews.
6. Install the anti-rotation bracket (HMO-1003) provided.
Mounting Method #3, for 3/8-inch diameter shafts
1. Note the direction of rotation.
2. Slide the shaft adaptor (HLO-1011) into the rear of the actuator.
3. Slide the actuator onto the shaft.
4. Slide the drive bushing (HLO-1006) onto the shaft and into the
actuator.
5. Align the actuator with the damper.
6. Align the drive bushing setscrews with the slots in the adaptor
and tighten the screws.
7. Install the anti-rotation bracket (HMO-1003) provided.
Mounting Method #4, for 3/8-inch SQUARE shafts
1. Note the direction of rotation.
2. Slide the collar (HLO-1016) onto shaft or correctly position
HLO-1009 on damper shaft to hold actuator in position.
3. Slide the actuator onto the shaft, noting the directional
rotation.
4. Slide the drive bushing (HLO-1006) onto the shaft.
5. Align the actuator with the damper.
6. Tighten the collar and drive bushing setscrews.
7. Install the anti-rotation bracket (HMO-1003) provided.
(Includes HLO-1006 and HLO-1016)
(HLO-1006) (HLO-1016)
BUSHING HLO-1016