KMC Controls VEB-56 Series - Manual (Page 2)

VEB-56 Series Valves 2 Installation Guide © 2013 KMC Controls, Inc. 050-019-61B
KMC Controls, Inc.
19476 Industrial Drive
New Paris, IN 46553
574.831.5250
www.kmccontrols.com
[email protected]
More Information
For actuator specifications
and other information, see
the MEP-7500/7800 Series
Data Sheet .
For wiring, feedback/
direction selectors, ac-
tuator/signal range reset
(auto-mapping), and other
information, see the MEP-
7500/7800 Series Installa-
tion Guide .
For models, specifications,
and additional information,
see the VEB-56 Series Data
Sheet on the KMC web site
( www.kmccontrols.com ).
For accessories, trouble-
shooting, and other
information, see the MEP-
7500/7800 Series Applica-
tion Guide .
Accessories/Repair Parts
CME-7001 Single auxiliary switch, 1 SPDT
CME-7002 Dual auxiliary switch, 2 SPDT
HMO-4536 Adjustable stop kit
MEP-7xxx Replacement actuator (see label
on actuator or data sheet)
Operation
After the mechanical and electrical installations
have been completed, cycle the actuator to verify
the direction of rotation for normal operation and
fail-safe if so equipped.
Maintenance
No routine maintenance is required. The motors are
permanently lubricated. Careful installation will also
ensure long term reliability and performance.
Wiring
Wiring is dependent on the type of actuator and
the desired options that are available. Consult the
actuator model label and then the relevant sections
in the MEP-7500/7800 Series Actuators Installation
Guide for detailed instructions on the applicable
wiring, feedback selector, and actuator/signal range
reset (auto-mapping) of the valve’s actuator. (See the
More Information section.)