Vmp2 netbootloader, P i n g – Kontron VMP2 User Manual

Page 101

Advertising
background image

VMP2

NetBootLoader

ID 24855, Rev. 02

© 2002 PEP Modular Computers GmbH

Page 5 - 27

P I N G

FUNCTION:

Verify operability of the Ethernet interface

SYNTAX:

ping <ip_addr> [-c <count>] [-s <size>]

… [-w <wait>]

where:

ping

command

<ip-addr>

parameter: value: numerical string
IP address of target: nnn.nnn.nnn.nnn

-c

option: count

<count>

parameter: value: numeric: “[n ... ]n”
number of packets to send

-s

option: size

<size>

parameter: value: numeric: “[n ... ]n”: bytes
size of packet to send

-w

option: wait

<wait>

parameter: value: numeric: “[n ... ]n”: seconds
wait time between packets

DESCRIPTION:

To verify the operational status of the Ethernet interface the command
“ping” is used. This command tests the network connection and target
server’s ability to respond.

If no other parameters are specified, four requests will be sent. This
can be changed with the parameter “-c”. The typical size of a ping
packet can be changed with the parameter “-s” and the time between
requests, which is typically one second, can be changed with the pa-
rameter “-w”.

Reponses to the “ping” command are dependent on the performance
of the network.

USAGE:

Send four packets

COMMAND / RESPONSE:

ping 192.192.158.7

Send ten packets, 100 bytes long, and wait two seconds between
packets

COMMAND / RESPONSE:

ping 192.192.158.7 -c 10 -s 100 -w 2

Advertising