Kontron CP6002 IPMI - Manual (Page 24)

IPMI Firmware User Guide CP6002
Page 24 ID: 1039-1613, Rev. 2.0
[1] Has OEM extensions. Please refer to 10.1, Get Device ID Command with OEM Extensions
[2] Response byte 2: hours, byte 3: minutes after module start. Bytes 4..6: void
Delete SEL Entry 40.8 Storage 46h O / Yes
Clear SEL 40.9 Storage 47h O / Yes
Get SEL Time 40.10 Storage 48h O / Yes
Set SEL Time 40.11 Storage 49h O / Yes
Get Auxiliary Log Status 40.12 Storage 5Ah O / No
Set Auxiliary Log Status 40.13 Storage 5Bh O / No
SERIAL/MODEM DEVICE COMMANDS O
Set Serial/Modem Configuration 25.1 Transport 10h O / No
Get Serial/Modem Configuration 25.2 Transport 11h O / No
Set Serial/Modem Mux 25.3 Transport 12h O / No
Get TAP Response Codes 25.4 Transport 13h O / No
Set PPP UDP Proxy Transmit Data 25.5 Transport 14h O / No
Get PPP UDP Proxy Transmit Data 25.6 Transport 15h O / No
Send PPP UDP Proxy Packet 25.7 Transport 16h O / No
Get PPP UDP Proxy Receive Data 25.8 Transport 17h O / No
Serial/Modem Connection Active 25.9 Transport 18h O / No
Callback 25.10 Transport 19h O / No
Set User Callback Options 25.11 Transport 1Ah O / No
Get User Callback Options 25.12 Transport 1Bh O / No
SOL Activating 26.1 Transport 20h O / No
Set SOL Configuration Parameters 26.2 Transport 21h O / No
Get SOL Configuration Parameters 26.3 Transport 22h O / No
Table 3: Standard IPMI Commands
COMMAND
IPMI 2.0
SPEC.
SECTION
NETFN CMD
KONTRON
SUPPORT
ON BMC