Kontron CP6003-RC uEFI BIOS - Manual (Page 43)

CP6003-SA/RA/RC uEFI BIOS The uEFI Shell
ID 1045-9149, Rev. 2.0 Page 43
P R E L I M I N A R Y
6.2.1 kboardconfig uEFI Shell Command
kboardconfig
FUNCTION: Configure non-volatile board settings
SYNTAX: kboardconfig
kboardconfig [-?|<device>|<setting>]
where:
? Show online help
<device> Specify device from list
<setting> Select configuration type
DESCRIPTION: The kboardconfig command is used to configure non-volatile board
settings.
USAGE: Show all possible configurations
COMMAND / RESPONSE:
Shell> kboardconfig
Control nonvolatile board settings
Example: kboardconfig
Pxe: PXE boot device ([disabled] all gbe_a gbe_b rear_a rear_b
gbe_e)
StorageOprom: Launch Storage PCI OPROM (disabled [enabled])
PrimaryDisplay: Select primary display device ([auto] igd peg pci)
Vga: VGA port configuration (auto [front] rear disabled)
SataMode: Determines how SATA controller(s) operate (ide [ahci]
raid)
WrProtSata: Onboard SATA flash write protection ([disabled]
enabled) !!! WARNING: CONTACT KONTRON BEFORE USING THIS FUNCTION !!!
WrProtEeprom: System EEPROM write protection ([disabled] enabled)
WrProtSpi: SPI boot flash write protection ([disabled] enabled)
IntelVirtualization: Intel VT-x ([disabled] enabled)
HyperThreading: Enable Hyper-Threading technology (disabled
[enabled])
CpuTurbo: Enable CPU turbo mode (disabled [enabled])
C3State: Enable CPU C3-state report to OS (disabled [enabled])
C6State: Enable CPU C6-state report to OS (disabled [enabled])
C7State: Enable CPU C7-state report to OS (disabled [enabled])
Show allowed settings e.g. for “PrimaryDisplay”:
Shell> kboardconfig PrimaryDisplay
PrimaryDisplay: Select primary display device
PrimaryDisplay == auto
Allowed options: auto, igd, peg, pci