Cp6004-sa introduction – Kontron CP6004-SA User Manual
Page 29
CP6004-SA
Introduction
ID 1052-8529, Rev. 2.0
Page 1 - 11
D R A F T — F O R I N T E R N A L U S E O N L Y
Chi
ps
et
Intel® QM77
Mobile Intel® QM77 Express Chipset:
•
Two x4 or eight x1 PCI Express 2.0 ports operating at 5 GT/s (only one
x4 PCI Express port is used on the CP6004-SA)
•
SATA host controller with six ports and RAID 0/1/5/10 support
•
Two SATA 6 Gb/s ports accessible via onboard connectors
•
Four SATA 3 Gb/s ports accessible via rear I/O
•
USB 2.0 host interface with up to 14 USB ports available (only six ports
are used on the CP6004-SA)
•
USB 3.0 host interface with up to 4 USB ports available (not used on the
CP6004-SA)
•
Integrated Ethernet controller
•
SPI flash interface support
•
Low Pin Count (LPC) interface
•
Power management logic support
•
Enhanced DMA controller, interrupt controller, and timer functions
•
System Management Bus (SMBus) compatible with most I²C™ devices
•
DMI 2.0 with 5 GT/s and FDI interfaces to the processor
•
High Definition Audio (HDA) interface
•
Analog display port
•
Three digital display ports
•
Integrated RTC
Integrated
Controller
Graphics controller
High-performance 3D graphics controller integrated in the processor:
•
Supports analog displays (CRT) up to a resolution of 2048 x 1536
pixels with 32-bit color @ 75 Hz
•
Supports digital displays (HDMI/DVI) up to a resolution of 1920 x
1200 pixels @ 60 Hz
•
Dynamic Video Memory Technology (DVMT)
Int
erfaces
CompactPCI
Compliant with CompactPCI Specification PICMG
2.0 R 3.0:
•
System controller operation
•
64-bit / 66 MHz PCI or PCI-X master interface with dedicated PCIe-to-
PCI-X bridge
•
3.3V or 5V signaling levels (universal signaling support)
Compliant with the Packet Switching Specification PICMG 2.16.
The CP6004-SA supports System Master hot swap functionality and applica-
tion-dependent hot swap functionality when used in a peripheral slot.
When used as a System Master, the CP6004-SA supports individual clocks for
each slot and the ENUM signal handling is in compliance with the PICMG 2.1
Hot Swap Specification.
When installed in a peripheral slot, the CP6004-SA is isolated from the Com-
pactPCI bus. It receives power from the backplane and supports rear I/O and,
if the system supports it, packet switching (in this case up to two channels of
Gigabit Ethernet).
Table 1-1:
CP6004-SA Main Specifications (Continued)
FEATURES
SPECIFICATIONS