13 advanced settings – remote access configuration, Advanced settings – remote access configuration, Bios setup – Kontron KTGM45-mITX User Manual
Page 82
KTGM45 Users Guide
KTD-N0793-O
Page 82
7.3.13
Advanced settings – Remote Access Configuration
BIOS SETUP UTILITY
Advanced
Configure Remote Access type and parameters
Select Remote Access
type.
<-> Select Screen
|| Select Item
+- change option
F1 General Help
F10 Save and Exit
ESC Exit
Remote Access [Enabled]
Serial port number [COM1]
Base Address, IRQ [3F8h, 4]
Serial Port Mode [115200 8,n,1]
Flow Control [None]
Redirection After BIOS POST [Always]
Terminal Type [ANSI]
VT-UTF8 Combo Key Support [Enabled]
Sredir Memory Display Delay [No Delay]
v02.67+ (C)Copyright 1985-2009, American Megatrends, Inc.
Feature
Options
Description
Remote Access
Disabled
Enabled
When Enabled then a remote PC can via one of the
serial ports behave like a TTY terminal, so that
keyboard and monitor (in a terminal window) is
emulated by the remote PC. As remote PC terminal
program the Windows Hyperterminal can be used.
Serial port number
COM1
COM2
Setup which comport that should be used for
communication
Serial Port Mode
115200 8 n 1
57600 8 n 1
38400 8 n 1
19200 8 n 1
9600 8 n 1
Select the serial port speed
Flow Control
None
Hardware
Software
Select Flow Control for serial port
Redirection After BIOS POST Disabled
Boot Loader
Always
How long shall the BIOS send the picture over the
serial port
Terminal Type
ANSI
VT100
VT-UTF8
Select the target terminal type
VT.UTF8 Combo Key Support
Enabled
Disabled
Enable VT-UTF8 Combination Key Support for
ANSI/VT100 terminals
Sredir Memory Display Delay
No Delay
Delay 1 Sec
Delay 2 Sec
Delay 4 Sec
Gives the delay in seconds to display memory
information
BIOS setup