Introduction am5010 – Kontron AM5010 User Manual
Page 30
Introduction
AM5010
Page 1 - 12
ID 1022-1107, Rev. 4.0
P R E L I M I N A R Y
LEDs
Module Management
LEDs
•
LED1 (red):
Out-of-Service LED
•
LED2 (red/green/amber):
Health LED
•
HS LED (blue):
The hot swap indicator provides basic feed-
back to the user on the hot swap state of the
module. The HS LED states are off, short
blink, long blink, and on.
User-Specific LEDs
•
ULED3 (red/green):
AMC Ethernet port A link signal status or
BIOS POST code LED
•
ULED2 (red/green):
AMC Ethernet port B link signal status or
BIOS POST code LED
•
ULED1 (red/green):
Freely configurable or BIOS POST code LED
•
ULED0 (red/green):
Freely configurable or BIOS POST code LED
Ti
m
er
Watchdog Timer
•
Software-configurable, two-stage Watchdog with programmable timeout
ranging from 125 ms to 256 s in 12 steps
•
Serves for generating IRQ or hardware reset
System Timer
•
The Intel® 3100 chipset contains three 8254-style counters which have
fixed uses
•
Real-time clock with battery backup
•
Hardware delay timer for short reliable delay times
IPMI
Module Management
Controller
•
Renesas H8 microcontroller with 40 kB RAM and redundant 512 kB
Firmware Flash with automatic roll-back strategy
•
The MMC carries out IPMI commands such as monitoring several
onboard temperature conditions, board voltages and the power supply
status, and managing hot swap operations
•
The MMC is accessible via a local IPMB (IPMB-L) and two host
Keyboard Controller Style (KCS) Interfaces
Hot Swap
The AM5010 has full hot swap capability.
Thermal Management
CPU and board overtemperature protection is provided by:
•
Four temperature sensors for monitoring the board temperature
•
Six processor sensors
•
One chipset sensor
•
Specially designed heat sink
Options
SATA HDD/SSD
The AM5010 provides interfacing for adding a single SATA hard disk drive or
solid-state disk drive via the assembly kit: AM5010M-MK2.5SATA. This kit
comes with a special SATA adapter which provides direct board-to-drive
interfacing for 2.5” SATA HDD/SSDs.
USB 2.0 NAND Flash
Up to 8 GB USB 2.0 NAND Flash can be added to the AM5010 using an
optionally available mezzanine module connected to J9.
Table 1-2:
AM5010 Main Specifications (Continued)
FEATURES
SPECIFICATIONS