Kontron MSM800SEL - Manual (Page 98)

MSM800SEV/SEL / Previous Product Versions
www.kontron.com 96
J17 10/100 BASE-T Interface Connector
Pin Signal
1 TX-
2 TX+
3 RX-
4 RX+
5 Activity LED
6 BAT Input 3.0-3.6V
7 GND
8 VCC 3.3V
9 Speed LED
10 Link LED
At the J17, the LAN interface board including the LAN transformator and the lithium RTC battery (for backup) must be
connected.
J18 PC/104+ BUS Interface
Pin A B C D
1 GND/5.0V KEY2 Reserved +5 AD00
2 VI/O AD02 AD01 +5V
3 AD05 GND AD04 AD03
4 C/BE0 AD07 GND AD06
5 GND AD09 AD08 GND
6 AD11 VI/O AD10 M66EN
7 AD14 AD13 GND AD12
8 +3.3V C/BE1 AD15 +3.3V
9 SERR GND SB0 PAR
10 GND PERR +3.3V SDONE
11 STOP +3.3V LOCK GND
12 +3.3V TRDY GND DEVSEL
13 FRAME GND IRDY +3.3V
14 GND AD16 +3.3V C/BE2
15 AD18 +3.3V AD17 GND
16 AD21 AD20 GND AD19
17 +3.3V AD23 AD22 +3.3V
18 IDSEL0 GND IDSEL1 IDSEL2
19 AD24 C/BE3 VI/O IDSEL3
20 GND AD26 AD25 GND
21 AD29 +5V AD28 AD27
22 +5V AD30 GND AD31
23 REQ0 GND REQ1 VI/O
24 GND REQ2 +5V GNT0
25 GNT1 VI/O GNT2 GND
26 +5V CLK0 GND CLK1
27 CLK2 +5V CLK3 GND
28 GND INTD +5V RST
29 +12V INTA INTB INTC
30 -12V Reserved Reserved GND/3.3V KEY2
Notes:
denotes power or ground signals.
The KEY pins are to guarantee proper module installation. PinA1 will be removed and the female side plugged
for 5.0V I/O signals and PinD30 will be modified in the same manner for 3.3V I/O. It is recommended that both KEY
pins (A1 and D30) be electrically connected to GND for shielding.
KCC boards have them as NC (not connected).
Signals used Onboard (not for external use):
IRQ3, IRQ4 COM1 /2
IRQ5 Sound
IRQ7 LPT1
IRQ6 FD
IRQ14 HD
IRQ12 PS/2 Mouse
IRQ13 Coprocessor
TC FD
DACK2 and DRQ2 FD