Kontron MSM-LP Manual User Guide V106 - Manual (Page 21)

MSM-LP / MSM-LP Connectors & Jumpers
www.kontron.com 17
3.2.11 AMP Power Input – X2/X3
The AMP power inputs are always connected on the top side of the board.
Header Nr. Signal Name Function
AMP 2.8mm X3 V5.0_IN 5 Volt power IN
Header Nr. Signal Name Function
AMP 4.75mm X2 GND Ground
X2 and X3 not equipped on system board.
3.2.12 LVDS Interface
The LVDS implementation complies with the JILI specification of Kontron (JILI30). When using an LCD, additional
voltages may be required to drive the display logic and supply the backlight converter therefore an additional
connector for supply voltages is provided.
The FPC connector is only mounted on the top side. The corresponding backlight connector is assembled on the
opposite side.
FPC Connector – X11
Header Pin Signal Name Function Pin Signal Name Function
1 FPC_AN First channel data out A 16 NC Not connected
2 FPC_AP First channel data out A 17 GND Ground
3 FPC_BN First channel data out B 18 NC Not connected
4 FPC_BP First channel data out B 19 NC Not connected
5 FPC_CN First channel data out C 20 NC Not connected
6 FPC_CP First channel data out C 21 NC Not connected
7 GND Ground 22 NC Not connected
8 FPC_CLKN First channel clock 23 NC Not connected
9 FPC_CLKP First channel clock 24 GND Ground
10 FPC_DN First channel data out D 25 SDA I2C data line
11 FPC_DP First channel data out D 26 DATAENA Panel power output
12 NC Not connected 27 SCL I2C clock line
13 NC Not connected 28 VCC +3.3V power *)
14 GND Ground 29 VCC +3.3V power *)
15 NC Not connected 30 VCC +3.3V power *)
*) Panel power can be set to +5V by assembly option.