Kontron COMe Ref.Carrier-i T10 - Manual (Page 10)

COMe Reference Carrier-i Type 10 / Specification
7
3.4 Electrical Specification
Supply Voltage
» Single Power Supply (5.5V – 20V DC)
When external devices are supplied by the COMe Reference Carrier-I Type 10 (via HDD power and LVDS connector) and
the temperature is below 0°C the carrier board supply voltage shall be > 6.5V.
Power Supply Rise time
» The input voltages shall rise from ≤10% of nominal to within the regulation ranges within 0.1ms to 20ms.
» There must be a smooth and continuous ramp of each DC input voltage from 10% to 90% of its final set-point
following the ATX specification
Supply Voltage Ripple
» Maximum 100 mV peak to peak 0-20MHz
Power Connector
» Pin / Ring Type with 2,1mm pin diameter