3 configuration, 1 dip switch configuration, Dip switch configuration – Kontron COMe-cP2020 User Manual
Page 38: Table 3-1: dip switch sw1 configuration, 3configuration
Advertising
www.kontron.com
COMe-P2020 User Guide
38
3
Configuration
3.1
DIP Switch Configuration
The COMe-cP2020 is equipped with one 4-bit DIP switch, SW1, used for board configuration.
Table 3-1:
DIP Switch SW1 Configuration
The default position for the above settings is: OFF.
SWITCH
SETTING
DESCRIPTION
1
OFF
Boot from the standard SPI boot flash
ON
Boot from the recovery SPI boot flash
2
OFF
The SDHC interface is routed to the onboard MicroSD
ON
The SDHC interface is routed to the COM Express connectorResaerved
3
OFF
Reserved
ON
4
OFF
Uses the SerDes configuration which is def ined via the U-Boot “sconf” command
ON
The COME-P2020 uses a default SerDes configuration
Advertising