Kontron KISS 4U X9SCAF - Manual (Page 24)

7. Product Description KISS 4U V2 – User's Guide (Version 1.01)
7.2.1.1.
Interfaces routed to the Rear Panel
Depending on the installed CPU card (motherboard or SBC) the on-board interfaces such as serial interfaces can be routed
to the rear panel (refer to Fig. 16, pos. 10 and pos. 12 and Fig. 17, pos. 6 und pos. 12). You can connect peripheral
devices to these connectors.
A detailed description of the ports can be found in the manual of the corresponding CPU card
(motherboard or SBC).
You can download the relevant CPU card manual for your system configuration from our web site at
www.kontron.com by selecting the product. See also “KISS 4U V2 Systems - Configuration Guides” on
our website.
7.2.2. Power Supply
The power supply is located on the rear side of the KISS 4U V2 platform.
On request, the KISS 4U V2 platform can optionally be equipped with an AC wide rage PSU, a redundant AC wide rage PSU
or a DC PSU. The integrated power supply version also depends on the ordered system version and system configuration.
The respective power supply version and the corresponding nominal voltage range can be found on the type label on the
right side of the system.
Fig. 18: Detail:
400W AC wide range PSU
Fig. 19: Detail:
650W AC wide range PSU
Fig. 20: Detail:
500W AC redundant wide range PSU
For system configuration with
24VDC/-48VDC PSU:
The green Power-ON LED (Fig. 21 and
Fig. 22) of the 24VDC / -48VDCPSU (on
rear side of the system) lights up, only
when the KISS 4U V2 systems is
powered on with the power button
(Fig. 12, pos. 3).
Power-ON-LED Power-ON-LED
Fig. 21: Detail:
+24VDC-Netzteil (400W)
Fig. 22: Detail:
-48VDC-Netzteil (400W)
www.kontron.com 23