Kontron KISS 4U X9SCAF - Manual (Page 28)

8. Assembly, Disassembly KISS 4U V2 – User's Guide (Version 1.01)
8.3. Fan Slide-in Module and Temperature Sensor
The two system fans (Fig. 27 and Fig. 47, pos. 3) are integrated in a user-friendly, replaceable fan slide-in module (hot-
swap). The fan slide-in module is mounted in a fan compartment on the front side of the system (Fig. 46, pos, 5).
The system fans are temperature controlled via the temperature sensors installed in the KISS 4U V2 platform. Thus, a
reliable air circulation for optimal active cooling of the platform is guaranteed.
The temperature conditions of the system (depending on the environmental temperature and the system load) are
detected by two temperature sensors. One temperature sensor is located in the rear part (near the ventilation openings)
and the second sensor is placed sideways in the mid part of the KISS 4U V2 platform.
2
4
3
1
Fig. 27: Fan slide-in module
1 Fan slide-in module with two knurled screws 3 2x fans (temperature controlled
independently from each other)
2 Connector for fan control
4 Bracket of the fan slide-in module
The operation of the KISS 4U V2 platform is permitted only with a functional fan slide-in module!
Defective components may only be replaced by Kontron original spare parts.
‰ “fan slide-in module”, part number: 1035-6968
Important Instructions!
The fan slide-in module can be replaced during operation. This should only be carried out by qualified
personnel aware of the associated dangers (see chapter 10.2 “Replacing the System Fans”).
www.kontron.com 27