Kontron OmniView - Manual (Page 16)

OmniView–User’s Guide (V1)
www.kontron.com 15
6.3.1. Display with Touch Screen
Depending on the OmniView ordered, the built-in display is a 15.6”/18.5”/21.5” size TFT display
with corresponding Projected Capacitive touch screen. The touch screen is USB connected.
For technical specification of the built-in display refer to chapter 9 “Technical Data”.
The display is equipped with a Projected Capacitive touch screen. The touch screen offers the
same degree of user comfort as the mouse buttons.
The surface of the display is also mechanically protected through the touch screen. The touch
screen (USB connected) registers contacts of a finger and allows moving the mouse pointer. This
functions only under integration of the necessary software. The corresponding touch screen
driver for your operating system is installed on your OmniView monitor.
Do not use a hard or a pointed object (like screw drivers) to operate the touch
screen; doing so may damage the touch screen surface.
The touch screen is covered with a glass panel and care should be taken when
cleaning it (see the section 8.1 “Touch Screen Care and Cleaning”).
6.3.2. Front Plate
The OmniView is suitable for installation in an instrument panel or other cabinet. At the front
side of the system, an aluminum front plate (bezel) with integrated anti-glare glass plate and
capacitive touch is located.
For the outline dimensions of the touch monitor base refer to section 10.2 “Mechanical
Specifications.”
6.3.3. Calibrating the Touch Screen
Unlike resistive touch displays, the capacitive touch screen needs no further calibration after
factory calibration. Only special, conductive styluses (not included) work with capacitive touch
screens.
The capacitive touch screen is factory-calibrated and needs no recalibration.
When using a stylus, make sure to use a special conductive stylus that works with
capacitive touch screens.