Kontron KBox B-101 Configuration Guide - Manual (Page 24)

8. Handling internal Components KBox B-101 – User’s Guide (Version 1.00)
8.1.3. Replacing the Lithium Battery
The integrated motherboard of your system is equipped with a lithium battery. To replace the battery, please proceed as
follows:
1. Open the unit as described in subsection 8.1.1”Opening and Closing the KBox B-101” (step 1-4).
2. Remove the lithium battery from the holder by pulling the ejector spring outwards.
3. Place a new lithium battery into the battery holder.
4. Pay attention to the polarity of the battery.
5. The lithium battery must be replaced with an identical battery or a battery type recommended by Kontron (Lithium
battery 3.0 V for RTC, type: CR2032).
6. Close the device, as described in the subsection 8.1.1 “Opening and Closing the KBox B-101” (step 5).
- +
Lithium battery
Fig. 18: Lithium battery
Caution
Danger of explosion when replacing with wrong type of battery. Replace only with the same or equivalent
type recommended by the manufacturer. The Lithium battery type must be UL recognized.
Do not dispose of lithium batteries in general trash collection. Dispose of the battery according to the
local regulations dealing with the disposal of these special materials, (e.g. to the collecting points for
disposal of batteries).
22 www.kontron.com