La-Z-Boy Power Recline prior to 11/28/2011 - Manual (Page 7)

13 12
– To reduce the risk of serious injury:
• Provide a clear path for operation of the back and legrest. Place tables and area rugs
at a distance to allow the legrest to fully extend without rubbing or interference.
WARNING
7. Adjustable glides are standard on modular units with metal base rails. Adjust the glides to a height
that provides an unobstructed path for operation of the legrest (see Furniture Placement Guide).
• Each glide is attached to the base rail by one jam nut and one lock washer on top of the latch
bracket, and one jam nut on the bottom of the base rail (F
IGURE 7). Loosen the jam nut located
on top of the latch bracket.
• Holding the top jam nut, turn the glide clockwise to lower the unit or counterclockwise
to raise the unit.
• Tighten the bottom jam nut to the base rail, and then tighten the top jam nut to the latch bracket.
• Repeat this step for each adjustable glide, as necessary.
8. Identify the electrical components to be used in the following assembly steps (F IGURE 8).
9. Locate the motor connector behind the power motion-modular unit.
10. Connect the power transformer to the motor connector (F IGURE 9).
11. Connect the 120 volt power cord to the power transformer (F IGURE 10). Do not plug in until
instructed in the operating instructions.
12. To remove the backs, unplug the 120 volt power cord from the electrical outlet and disconnect
the power transformer from the motor connectors behind the power motion-modular unit.
Reverse the Assembly Instructions steps.
F IGURE 7 F IGURE 8
F IGURE 9 F IGURE 10
Base Rail
Power
Transformer Motor
Connector
Jam Nut
Lock
Washer
Jam Nut
Adjustable
Glide
Make this
connection
120 Volt
Power Cord Power
Transformer
Make this
connection
(Power Motion-Modulars Assembly Instructions Continued)
La-Z-Time ® Power Motion-Modulars
Assembly Instructions
La-Z-Time ® Power Motion-Modulars
Assembly Instructions
Latch
Bracket
Power
Transformer 120 Volt
Power Cord