Lifesmart LS-4CH-SIQT-D - Manual (Page 11)

11
OPERATING INSTRUCTIONS
1. Turn the heater on or off by pressing the Power
button on the control panel (C) or by pressing the
ON/OFF button on the remote control (B).
Once the power is off, heating elements will stop
working first. The fan will continue working for up to 3
minutes to dispense residual heat inside the heater.
This is a normal function.
1
POWER
C B
2. Select a heat setting by pressing the MODE button
on either the control panel (C) or the remote control
(B) to toggle between the three heat settings.
Power for heat-up mode is 1,500 W; heat-down is
750 W. ECO mode is an Economic Energy Saving
Function. When ECO mode is chosen, the heater will
operate to maintain a constant warm 68°F
2
HIGH LOW ECO
HEAT
C B
3. Set the thermostat by pressing the arrows on the
control panel (C) or the remote control (B).
You can set the temperature on the heater anywhere
between 50°F and 97°F or between 10°C and 36°C.
Once you have chosen the desired temperature,
the heater will remain on until the room temperature
increases to the temperature on the digital display.
The heater will cycle on and off to maintain the
desired room temperature.
To view the ambient room temperature press and
hold the Temp Up button on the control panel (C)
for 3 seconds. The ambient room temperature will
display for approximately 5 seconds then revert back.
To switch the digital display indicator on the heater
between Fahrenheit and Celsius, Press and hold the
Oscillation button on the control panel for 3 seconds.
3
C
C
B
TEMP.
UP
TEMP.
DOWN
OR