Losi LOSB0126 - Manual (Page 8)

8
Telemetry Sensors
• The battery power of the receiver pack will automatically
register on the readout screen.
• The engine temperature requires that the temperature
sensor (SPM1450) be installed around the head just above
the head bolts as seen in the photo. Note: The temperature
sensor must be removed before removing the head from
the engine. There is an external plug near the radio box
which will allow you to disconnect it if you wish to remove
the engine for cleaning.
• The RPM/Speed sensor is mounted directly below the rear
transmission input connector. The connector has a silver
stripe on it that the sensor reads. Both of these items have
to be kept clean for proper operation. Use compressed
air or a soft brush to remove dust or dirt that can prevent
operation. NEVER use any kind of solvent on either of
these as it will cause the stripe to fall off and the sensor to
fail. If the stripe should fall off replace it with one from the
(SPM1512) Telemetry RPM Sticker Sheet.
Binding the Radio System
Steps to Re-Bind
1. Make sure both the transmitter and the model are
turned off.
2. Unplug the bottom plug in the receiver port marked
BIND/RS.
3. Install the bind plug into this port.
4. Remove either of the two plugs directly above the bind
plug – Do Not use any other port.
5. Install the plug that was removed from the bottom port
(BIND/RS) in step 2 into the open port from step 4. See
photo.
6. Turn on the model – an LED located beneath the “m” in
Spektrum when viewed from the side will start blinking.
The radio is now ready to bind.
7. Turn on the transmitter and depress the selector wheel
twice which will bring up the “LIST” screen.
8. Roll the selector wheel down until it highlights “BIND” and
press it once to bring up the Bind screen.