Losi LOSB0290 User Manual
Page 11
TM
Note: Please read the entire manual to gain a full understanding of the 1/10 Slider
vehicle, fine-tuning the setup and performing maintenance.
1. Read the safety precautions found on page 3. This is important for your safety and
prevention of personal injury.
2. Charge the battery pack you have chosen (NOT INCLUDED). Refer to the
manufacturer’s supplied instructions for battery charging information.
3. Install the AA batteries into the LSR-3000 transmitter (see page 9). Use alkaline or
rechargeable batteries only.
4. Install the battery pack (see previous page). The battery pack should be fully charged
before installation.
5. Turn on the transmitter and then the vehicle. It is a good practice to
turn on the transmitter before the vehicle and turn it off after the vehicle has
been turned off.
6. Check steering (see page 12). Verify that the servo is functioning properly.
7. Driving the 1/10 Slider (see page 14).
8. Performing maintenance of the 1/10 Slider. Refer to Tuning, Adjusting and
Maintenance of the 1/10 Slider on page 15.
Quick Start