Losi LOSB0290 - Manual (Page 4)


TM
Supplied tools:
2-Way wrench
Transmitter / Receiver BIND Plug
Two (2) Hex Wrenches (L shaped)
1/16 and 3/32
Flat Turnbuckle Wrench
Recommended Accessories:
- Hobby grade knife
- CA glue (LOSA7880 or LOSA7881)
- Needle nose pliers
- Side cutting pliers
- Double-sided tape (LOSA4004)
- Safety Goggles
- Soldering iron
Required Equipment:

A Six (6) cell NiMH battery pack. Or with proper knowledge,
LiPo battery packs.

NiMH battery charger with automatic “peak detection”
recommended.
Using your charger:
If you do not yet have a charger, a peak detecting charger
will provide the performance required and take care of your
expensive batteries.
A popular choice for a charger would be a peak detection
charger that can be plugged into a household AC wall socket.
The peak detection portion of the charger monitors the battery
charging and will automatically shut off upon full charge.
Other peak detection chargers require a 12V power source to
charge your batteries. You would need to use or purchase a
hobby grade 12V power supply before charging.
If you are going to be using a charger other than a peak
detection charger it is important to have your battery fully
discharged prior to recharging. Many of these have a 15-20
minute timer that allows you to set the amount of charge time.
If the battery was not fully discharged from prior use, you can
potentially overcharge your battery pack.
Do not charge any battery unattended, and monitor for
heat build up. If the battery pack is more than warm to the
touch immediately discontinue charging.
Read all safety precautions supplied by the charger
manufacturer, and also any from the battery manufacturer.
Vehicle Battery
(6-Cell 7.2V “Stick Pack”)
LOSB9900
DYN4044 Vision Peak™ 2 AC/DC Charger
Supplied and Required Equipment