Cco od de e h ho op pp piin ng g – CLIFFORD Matrix 12 User Manual

Page 27

Advertising
background image

22

© 2 0 0 6 d i r e c t e d e l e c t r o n i c s

Example

If Zone 3 was active or triggered, the LED will blink three times

with a two-second pause. Then it will blink three times again,

and repeat until the ignition is turned on.

c

co

od

de

e h

ho

op

pp

piin

ng

g

The receiver and remote controls each use mathematical

formulas called algorithms to change their codes each time the

remote control is used. This technology has been developed to

increase the security of the unit. The control unit knows what the

next codes should be. This helps to keep the remote control "in

sync" with the control unit even if you use the remote control out

of range of the vehicle. However, if the remote control has been

pressed many times out of range of the vehicle, or if the battery

has been removed, it may get out of sync with the control unit

and fail to operate the system. To re-sync the remote control

simply press

of the remote control several times within range

of the vehicle. The alarm will automatically re-sync and respond

to the Remote Controls normally.

note: Your system stores the last six triggered zones in
memory. If your system has been triggered but the LED
has been reset by turning on the ignition, your dealer can
still recall the last six zones that were triggered. Contact
your dealer for details.

Advertising